Change EMLF boundary condition with Python

[gbgbha]

Hi all,
For my EMLF simulations, I need to adjust the voltage in order to get the appropriate current and then run the simulations again. How can I programmatically change the boundary condition of an existing simulation?

[montanaro]

Easiest way is to right click on your simulation and click on 'To Python..'

Run this to make sure it works. It should create a new simulation with the exact same parameters. You can then change whichever parameter you like and run it again

Note: If I remember correctly, if you use 'To Python', a lot of the default settings won't show up in the code. if they don't show up (like the boundary condition),change them to some non-default value in your simulation before using 'To Python'.